Slicer Discord
Lighthouse and Benchy – 3D-Druckmodell von MakerOnline MakerOnline
Lighthouse and Benchy – Bild 1 Lighthouse and Benchy – Bild 2 Lighthouse and Benchy – Bild 3 Lighthouse and Benchy – Bild 4 Lighthouse and Benchy – Bild 5 Lighthouse and Benchy – Bild 6
Toys&Games

Lighthouse and Benchy

480 Downloads
229 Likes
0 Makes
Zum Modell
benchy小船在随着波浪上下浮动,前面是金色的小鱼群在不断跃出水面,远处是灯塔的金黄色的探照灯在不断旋转。 Benchy's small boat was floating up and down with the waves, with a group of golden fish leaping out of the water in front, and the golden searchlight of the lighthouse spinning in the distance. 以下是安装图示: The following is the installation diagram: 为了稳定你的benchy,可以把它粘在中间高起的那片浪花上。 o stabilize your bend, you can stick it to the rising waves in the middle. 安装完成的整体尺寸大约长160mm,宽100mm,高150mm。 The overall dimensions after installation are approximately 160mm in length, 100mm in width, and 150mm in height.
Kategorie
Toys&Games
Quelle
MakerOnline
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

PandaN veröffentlicht auch auf

137 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen