Lights for Creality 3D Printer Enclosure

Body printed in vase mode, solid base pops out very easy.

Body sections glued together with couplers.

Tapered End caps press fit into body.

Assembly:
- Glue lengths of body and couplers
- Route led strips through slots (wires pre-soldered)
- Install sockets into endcaps, pre-soldered wires (1 long that runs through the groove in the back, one short)
- Press fit end cap with long wire into one end of the body, run cable through groove. Hold in place with some hotglue
- Solder/crimp all wires together (4 pairs, 2 led strips and 2 endcaps)
- Test led strips
- Press Fit final end cap in place


https://www.creality3dofficial.com/products/3d-printer-enclosure-safe-quick-and-easy-installation

Holds two parallel lengths of LED strip: https://nl.aliexpress.com/item/1005002230353875.html

Total power consumption for 5 sections in photo ~0.6A@12V. 1A power supply is sufficient: https://nl.aliexpress.com/item/33042352760.html

Daisy chained using 5.5x2.1 jacks: https://w