Lightsaber hilt

parts are numbered according to their position (except 1 and 2 but that's not to hard to figure out). if you want it looking nicer i suggest cutting out segments from aluminum cans with these dimensions:

for part 3 cut out 8 10X90 mm rectangles

for part 5 cut out 1 55X58 mm rectangle

for part 6 cut out 4 23X30mm rectangles

insert these into the slits on the respective parts before you glue the parts together, use the registrator to align the parts so they're centered. The prongs are glued into the inset sections on part 6. if printed correctly they should fit well inside.