Thingiverse
Lightsaber Stand
von AndyCa
45
Downloads
65
Likes
0
Makes
A quick display base for Lightsabers. Its nothing fancy, basic and doesn't detract from the saber, but paints up well enough.
The base is split into two halves, and likewise the support brackets, so you'll need to print two of these and glue them together( its too big to print in one go on my printer) . The support brackets get glued on top of the whole thing and to the round section of the base ( look at the image for glueup guide )
Again, nothing fancy, it just works..
The base is split into two halves, and likewise the support brackets, so you'll need to print two of these and glue them together( its too big to print in one go on my printer) . The support brackets get glued on top of the whole thing and to the round section of the base ( look at the image for glueup guide )
Again, nothing fancy, it just works..
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
