Lightsaber Wall Mount

I wanted a smaller profile mount for my lightsabers, so created my own. My hilt bases have a 1.4715" diameter, so the base inset was designed just over 1.5". Very straightforward print that does not require any supports. The bottom of the base support is open in case you want to direct wire power to the hilt like I eventually will.

Saber can either snap into top or slide up into it (less chance of scratching). You may want to add felt or something to the inner top ring just to protect it.

The middle base in the photo was the original design, which was bigger, but the two outer bases are the current, narrower design.

Enjoy!