Lightsaber Wallmount

This is a universal wallmounting system for Lightsabers with a 2.54cm (1 inch) blade.
The holder itself is printed best upright to ensure the holderclamps dont break.
For the logo i recommend printing it flat on the bed with Ironing (in Cura for example) enabled. This way to logo comes out smoothly.

There are 2 notches on the back of the holder to glue in place the logo if you wish so. But it is not needed to function. As glue i just used superglue. Hotglue may not work due to forming a gap between the two parts.

The two holes are 3mm in diameter and are countersunk to ensure flush mounting.

I've used wall anchors since my house is very old.