Lily Light

This was a flower that I designed based off of the photo attached. My daughter really wanted a lily so I did my best to make it appear as close to the actual photo as possible. The print is set up into two prints, the backside which has a hole for hanging and a hole for any LED wires that may need to be ran. Then there is the front side which has the “meat” of the flower. The print has pins built into the back side in order to align it correctly. Feel free to modify the support as you see fit but I found that the way I have it gives the best result. It will take a bit to remove but as its on the inside it really isnt that bad. You can add the color adjustments to the center of the flowers within the slicer or you can do like I did and just outline it with a black sharpie. My daughter really likes it and I hope others will too. Enjoy!MembershipSubscribe for full access to all of my 3D prints!