Thingiverse
Limit switch bracket for micro switches
von Monberg75
3
Downloads
0
Likes
0
Makes
Made this bracket for limit switches.
Fits well on my Bulkman3D Ultimate Bee.
Use 3x15mm screws for microswitches
Use 5x10mm screws for mounting along with t-nuts for the extrusion.
Can be used on every rail on every end.
Print with 25% infill at 0.2mm layer height and 5 walls.
If you want, make m3 thread for the microswitch holes, and bore out the mounting holes to 5mm to make sure the screws will fit.
Fits well on my Bulkman3D Ultimate Bee.
Use 3x15mm screws for microswitches
Use 5x10mm screws for mounting along with t-nuts for the extrusion.
Can be used on every rail on every end.
Print with 25% infill at 0.2mm layer height and 5 walls.
If you want, make m3 thread for the microswitch holes, and bore out the mounting holes to 5mm to make sure the screws will fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!