Thingiverse
Limitless (Liberty) paramotor strobe mount
door Olooki3D
0
Downloads
2
Likes
0
Makes
Most of the paramotor strobe mounts on this site are for a strobe that is no longer available, so I created this. This strobe mount for this strobe set from Amazon: https://www.amazon.com/dp/B0BM9ZJ1K6?ref=ppx_yo2ov_dt_b_product_details&th=1 that has a tested 3.7-mile visibility range.
This mount uses dual mount techniques, screws and zip ties. The last thing you want is anything coming lose and going through your prop.
Print two of these and put them back to back and screw them together with either 4 short drywall or wood screws. Then run 2 zip ties through the slots to add a redundant attachment method. (You may have to enlarge the screw holes appropriately for your screws.
Note, I added a couple of short strips of double sided 3m tape on either side of my crossbar before I screwed the bracket to it. This will prevent the mount from spinning or sliding sideways on your crossbar.
You can then use the 3m mounting adhesive that comes with the strobes to mount one on the to
This mount uses dual mount techniques, screws and zip ties. The last thing you want is anything coming lose and going through your prop.
Print two of these and put them back to back and screw them together with either 4 short drywall or wood screws. Then run 2 zip ties through the slots to add a redundant attachment method. (You may have to enlarge the screw holes appropriately for your screws.
Note, I added a couple of short strips of double sided 3m tape on either side of my crossbar before I screwed the bracket to it. This will prevent the mount from spinning or sliding sideways on your crossbar.
You can then use the 3m mounting adhesive that comes with the strobes to mount one on the to
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
