Slicer Discord
Line Recording Bookmark – 3D-Druckmodell von Thingiverse Thingiverse

Line Recording Bookmark

von FactorX12
8 Downloads
4 Likes
0 Makes
Zum Modell
Are you ever forced out of a book, halfway through the page? Then when you get back to reading it, you have to skim over the entire page to find where you left off? That happens to me sometimes, as well. I designed this to fix that problem. Basically, what happens is, when you leave off at a certain line, you slide the slider to point to that line, and then you close the book on it. (Try and close the book on it as close as possible to the spine, so you don't have to worry about the slider sliding around when you're not reading the book.) Not only does it save the page you're on, but it saves the line too! You're welcome. And hey, another pre-sliced object for ya! :)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen