Linear antenna standoff mount

UPDATE: I just added version 2 (linear standoff mount v2). I changed the angle to be a little more upright and lined the holder up a bit more with the standoff. I find with the first version it gets in the way of the props easily if you don't have it lined up perfect. This new version makes that much less an issue as it gets the antenna up out of the way and lined up in the center better.

This is a standoff mount for your 5.8GHz linear antenna (also called whip antenna). After printing in a flexible filament like TPU, thread the antenna cable through the longer horizontal cylinder and press the antenna in. It should be a snug fit so the antenna doesn't pop out or move. It if it's snug, scale your print down a percent or two in the slicer and print again.

Then just slide the antenna over any standoff on your drone.