Thingiverse
Linear Bushing for 10mm Rail
von SafireBlasters
16
Downloads
20
Likes
0
Makes
10mm bushing for linear rails. Best if printed in nylon, but PLA works too.
If bearing sticks initially, try manually running it up and down the rail a few times to break it in. Use a lubricant that won't eat away at your plastic.
10.25mm ID - If your printer prints holes a bit too small
10.1mm ID - If your printer has really good tolerances
You may have to scale incrementally to get the perfect fit.
20mm OD
40mm Length
Channels for cable tie mounting
If bearing sticks initially, try manually running it up and down the rail a few times to break it in. Use a lubricant that won't eat away at your plastic.
10.25mm ID - If your printer prints holes a bit too small
10.1mm ID - If your printer has really good tolerances
You may have to scale incrementally to get the perfect fit.
20mm OD
40mm Length
Channels for cable tie mounting
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
