Thingiverse

LINEAR RAIL SPACERS ENDER 5 PLUS

by Maltvat

23 Downloads

6 Likes

0 Makes

This thing is meant to be used to make sure your bed carriage is level. You need to print 4 of this part, place one on each of the 4 guide rods and then move the bed up until there is no gap.

If your z axis moves down when the printer is off, or like me your bl touch was off the bed when you were homing your z axis then you need to re-level your bed carriage. This will help with that.

This spacer is long enough that the stock Ender 5 + hotend will not be able to touch the bed when you tighten the z axis, so no fear of it crashing.

Autolevel auto bed leveling bed level bed leveling Ender ender 5 Ender 3 level leveling linear linear bearing linear motion linear rail linear slide spacer Autolevel auto bed leveling bed level bed leveling Ender ender 5 Ender 3 level leveling linear linear bearing linear motion linear rail linear slide spacer

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format