Thingiverse
LinkTap Gateway Wall Mounting Bracket
por eddytheflow
4
Descargas
2
Likes
0
Makes
Liked this mounting design so remixed it again for my LinkTap Gateway.
Again, reinforced the side braces as they were too flimsy when I printed them before.
If I were to make again, I would add maybe 1-2mm of play around the base. It fits snugly, quite tight, maybe too tight. At least it's secure!
Again, reinforced the side braces as they were too flimsy when I printed them before.
If I were to make again, I would add maybe 1-2mm of play around the base. It fits snugly, quite tight, maybe too tight. At least it's secure!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!