Thingiverse
LinnStrument strain relief
di MrRodent
1
Download
1
Likes
0
Makes
As I found myself playing the LinnStrument standing quite a bit, I wanted to make a bit more permanent solution than tying the USB cable to a strap button.
The strain relief becomes a part of the cable and allows fast sliding on and off from the instrument. It's strong enough to hang the whole instrument from the cable (of course I had to try).
The base (part 1) is screwed in place with one of the strap button screws that was provided with the instrument. Use few drops of super glue to put the lid in place to the part 2.
PRINTING INSTRUCTIONS:
Print parts 1, 2 and the lid with the flat sides down, no supports needed.
I printed on a raft, but it should work without.
The actual print takes around 4g of plastic and prints in less than an hour.
I've provided STEP and original SolidWorks files for easy remixing.
The strain relief becomes a part of the cable and allows fast sliding on and off from the instrument. It's strong enough to hang the whole instrument from the cable (of course I had to try).
The base (part 1) is screwed in place with one of the strap button screws that was provided with the instrument. Use few drops of super glue to put the lid in place to the part 2.
PRINTING INSTRUCTIONS:
Print parts 1, 2 and the lid with the flat sides down, no supports needed.
I printed on a raft, but it should work without.
The actual print takes around 4g of plastic and prints in less than an hour.
I've provided STEP and original SolidWorks files for easy remixing.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
