Lion King Lithophane

Watch here: https://youtu.be/jH_rpieYP1U

This was a request I had gotten and I'd never heard of a Lithophane so I looked into it and this is what I came up with! I did most of the legwork in getting the images separated into parts in Paint.net.

Then after that I imported them into Tinkercad, arranged them and layered them at different heights so light would travel through them differently. I made the mistake of printing with a low infill. I would recommend going higher with that.

Image to SVG:
http://image.online-convert.com/convert-to-svg

Image to Lithophane:
http://3dp.rocks/lithophane/

Print Settings:
Printer: Robo3D R1
Filament: Hatchbox Clear PLA
Layer Height: 0.3mm
Infill: 30% (I would recommend higher)
Supports: No
Raft: No