Slicer Discord
Liquid Soap Dispenser Limiter Ring – 3D-printbaar model van Thingiverse Thingiverse

Liquid Soap Dispenser Limiter Ring

11 Downloads
9 Likes
0 Makes
Model downloaden
This is a very simple ring that snaps around the neck of a liquid soap dispenser in order to limit the distance it can travel. Basically you get less soap per pump. I'm sure it can help save money, but my main motivation is that I get way too much soap and half of it invariably ends up sliding off my hand and into the sink and I can't stand the waste.

Parameters:
clip ID - this is the inner diameter of the clip. Grab the calipers and measure the diameter of the neck to get this value.

clip thickness - this is how hefty you want the ring to be. Too much and it'll snap, too little and it'll work its way off. You may want to fiddle around with this combined with infill to get it just right. I find around 2mm with a 20% infill to be perfect for my use.

clip height - this is the limiting part. Start by measuring the height of the neck and then divide by 2, then work your way up or down depending on how well it works. These only take about 5 minutes to print and use around 10
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie