Liquid Transfer Pump Wipers

Will fit various pumps Including but not limited to; 12v 15GPM 120V 22GPM I have a “Roughneck” flammable transfer pump, shown in the photo, where the brushes (vanes) or wipers wore out and became lodged and some were missing. Obviously, the photo I have included is the “before”. I was too impatient to stop and take an “after” photo. Sometimes typical of me. I started with one of the “fins” or “blades” that were still intact and designed an exact replica to replace the worn part. This pump is a 120V electric pump or 12v DC designed to transfer flammable fluids. Hence why the brushes are made of plastic. I printed them in Polycarbonate (PC) and they work fantastically. With the springs listed below you have an entire rebuild kit for this pump. The file would work with any filament that is compatible with petroleum products or chemical resistant. For short term, you could probably use PETG, ABS, or long term PA6 or PA12, I do not advise using any filaments with additives such as CF Carbon