Thingiverse
Lithium Maintenance Charger
von databeestje
7
Downloads
5
Likes
0
Makes
This is a board that allows for mounting a number of USB chargers and TP4056 boards and relays (5V DPDT) to decouple everything.
I am building a 8S Lithium (maintenance) charger that charges each cell independently and decouples from the battery entirely when power off.
Print without support ideally, otherwise the bottom of the Euro socket is a hassle.
You can change the direction of the charger boards vertically or horizontally, depending on which way you want to mount the charger boards. A fan with duct might be a solution in the longitudinal direction.
I am building a 8S Lithium (maintenance) charger that charges each cell independently and decouples from the battery entirely when power off.
Print without support ideally, otherwise the bottom of the Euro socket is a hassle.
You can change the direction of the charger boards vertically or horizontally, depending on which way you want to mount the charger boards. A fan with duct might be a solution in the longitudinal direction.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
