Lithopane night light ver 1

Updates: Added one version "base_with_lid_ver1" if you don't like glue the lid and base together, but I believe you will need a lot of support.

Below are the original notes:
> Super glue required.
> Can fit in 4 lithopane prints with size 100mmx75mm, from edge to edge. The cavity on the night light is designed to be 100.5mmx75.5mm to accommodate some tolerances.
Print out 4 legs.
> There is an additional hole on the base for threading in the electrical wires to power up the LED strip (5-6pcs should be enough depending on which LED strip you plan to use.) You can use a bit hot-glue to hold the wire in place at the 4mm hole.
> The "Happy birthday" panel you can create your own, thickness 1mm, size 100x75mm exact.

Leave your comments here if you have any good suggestions.