Lithophane 8 sides edited

Instructions
The lamp:

(1) Use this website to make the lithophanes:
Here is the exact process I used:

Image:
Picture Shape: Square
Picture Orientation: Horizontal
Pane Size: Large
Invert Colors: Checked
Adjustments:
Include Hole: No
Hole Diameter: [Doesn't apply]
Layer Height: 0.2
Number of Layers: 20
Slicer (KISSlicer to be exact)
Height from 4.4mm to 3.2mm
If the customizer errors for you, see user "dlee_maker" comment on an alternative lithophane generator.

(2) Print your lithophanes and scale to 76 x 76 x 3.2 mm. (Change the print height in your slicer and the x, y dimensions should be correct.) Printing anywhere 0.1mm - 0.2mm is great with 100% infill.

(3) I used ABS; the LEDs get the structure up to 50-60C. PLA will work by limiting the LED brightness if it gets much hotter.

(4) If you normally use "ABS juice", use a glue stick this time. Cleaning the residual slurry off the flat side will be unsightly (as it is the outside part of the lithophane.)