Lithophane Box

http://www.facebook.com/JSQUAREDPRINTS

TO DO YET

Add Switch to Battery Version
Make Compartment sized for common RGB Strips plug (the four pin)
Increase tolerances on the posts as it's very tight side to side
Recess Bolt Heads on lid
Fix the slight hole/overlap from barrel plug hole
Add Magnetic Lid to hot swap panels quickly



Box Settings:
All M3 Hardware. I will be using M3 x 20 for everything to keep is simple.

The stand print settings are not as important. I used 0.3mm layer height at 10% infill.

Barrel Version uses 5.5 x 2.1 mm Barrel.

Barrel tolerances are tight. I sanded the plastic on the barrel on all 6 sides and it stays in friction fit.

Barrel Version you will want to use the CenterSmall Taller version.

Lithophane Settings on http://3dp.rocks/lithophane
Used 3dp.rocks/lithophane to create the lithophane models.
Photos of my settings attached as well.
Printed lithophanes vertically at 0.1mm layer height at 99% infill.

MODEL SETTI