Thingiverse
Lithophane Display Box
by Mystik738
21
Downloads
12
Likes
0
Makes
A box that can be used to display 4 by 6 inch lithophanes. Designed to fit flat lithophanes, 152mm by 102mm (some leeway in those numbers) that are up to 3mm thick, however you may want thinner ones depending on your lighting conditions.
Additionally requires an LED strip that may need to be glued to the inside of the box. If you can't glue them in, there's additionally a bracket that you can print twice and then thread the LEDs through.
Additionally requires an LED strip that may need to be glued to the inside of the box. If you can't glue them in, there's additionally a bracket that you can print twice and then thread the LEDs through.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!