Thingiverse
Lithophane Frame Curved
von DR82
3k
Downloads
2.2k
Likes
21
Makes
RECENTLY ADDED FILE: (CurvLid150prc4to3.stl and Curv150prc4to3.stl) This is the 150% size and 4:3 ratio. So for example if you have a picture that is 1600 x 1200 pixels this is the one to use. When using 3dp.rocks set size 150 mm max. I have not tested it yet but it should work fine.
(Litho1pic4to3CurvedSize2.stl) It is a stand holding one lithophane, assuming max size is 100 mm and it is for lithophane created from a picture with a 4 to 3 aspect ratio. Also added Versions with no holes for electric plug. They are NoHoleCurved with either 1 to 1 ratio for 100mm x 100mm lithophane or 4 to 3 ratio.
This is a frame I designed using Tinkercad. It is designed for curved lithophanes made from square pictures. I make the lithophane by going to this website http://3dp.rocks/lithophane/ and use model size of 100 mm with a 3mm frame. When the model is curved then the STL object will have the size of X=21.6mm, Y=94.0mm, Z=100mm and I position it along the Y direction on the bed for better qu
(Litho1pic4to3CurvedSize2.stl) It is a stand holding one lithophane, assuming max size is 100 mm and it is for lithophane created from a picture with a 4 to 3 aspect ratio. Also added Versions with no holes for electric plug. They are NoHoleCurved with either 1 to 1 ratio for 100mm x 100mm lithophane or 4 to 3 ratio.
This is a frame I designed using Tinkercad. It is designed for curved lithophanes made from square pictures. I make the lithophane by going to this website http://3dp.rocks/lithophane/ and use model size of 100 mm with a 3mm frame. When the model is curved then the STL object will have the size of X=21.6mm, Y=94.0mm, Z=100mm and I position it along the Y direction on the bed for better qu
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
