Thingiverse
Lithophane Holder
door krazzzyb
15
Downloads
8
Likes
0
Makes
I wanted a light box and a light source that didn't cost an arm and a leg for small projects. I went on a search for cheap lights that could be bright enough to light a Lithophane. I found these cheap night lights on amazon and they were about $10 for 6 of them.
https://www.amazon.com/Solatec-Adjustable-Brightness-Bathroom-Stairway/dp/B08GL6F9V4/ref=sr_1_7?dchild=1&keywords=night+light&qid=1628215947&smid=AM7I51ICJDYCZ&sr=8-7
To get them to be as bright as possible you have to turn it to Bright and CW and also CUT OUT THE PHOTOCELL to force it to be full bright.
I used ITSLITHO.com to make the litophane. The size is 100mm x 70mm with a 3 wide boarder and 4 mm thick.
It can be printed with no supports, I printed it with variable layer height, but i'm sure any layer height will do.
https://www.amazon.com/Solatec-Adjustable-Brightness-Bathroom-Stairway/dp/B08GL6F9V4/ref=sr_1_7?dchild=1&keywords=night+light&qid=1628215947&smid=AM7I51ICJDYCZ&sr=8-7
To get them to be as bright as possible you have to turn it to Bright and CW and also CUT OUT THE PHOTOCELL to force it to be full bright.
I used ITSLITHO.com to make the litophane. The size is 100mm x 70mm with a 3 wide boarder and 4 mm thick.
It can be printed with no supports, I printed it with variable layer height, but i'm sure any layer height will do.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
