Thingiverse
Lithophane House
door 8BitPoro
24
Downloads
8
Likes
0
Makes
If you can't print this, please consider ordering it through my 3DHub at:
http://3dhubs.com/service/8Bit
Lithophane house. You must make sure the picture is sized to 800x800 and then, through 3Dprinting rocks, set the image to NORMAL, maximum size of 125mm, 3mm thickness max, 3mm boarder, leave base and stand depth and curve all at 0.
The hole in the bottom is large enough to put a wall plug through, so you can use most light fixtures, including a standard LED bulb.
Use supports for the base only, supports are not needed for the roof.
http://3dhubs.com/service/8Bit
Lithophane house. You must make sure the picture is sized to 800x800 and then, through 3Dprinting rocks, set the image to NORMAL, maximum size of 125mm, 3mm thickness max, 3mm boarder, leave base and stand depth and curve all at 0.
The hole in the bottom is large enough to put a wall plug through, so you can use most light fixtures, including a standard LED bulb.
Use supports for the base only, supports are not needed for the roof.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!