Lithophane Lamp

Lithophane Lamp was printed in hatchbox PLA wood filament and the cover is a clear PLA. I thought I might have issues with heat from the bulb but it doesn't get too hot and I leave mine on 24/7 without issues.

Electronics are taken from a Walmart lamp.
https://www.walmart.com/ip/Mainstays-LED-Desk-Lamp/49333225

I created the lamp around parts taken from this lamp because it is has all of the components needed and is inexpensive, only about $6 when I made this.

Create lithophane on this site http://3dp.rocks/lithophane/
use the settings shown in the photos.

Just wire the lamp the same way it was wired in the original lamp and then superglue the cover over the LED.
I may post better instructions later on if I have time. If you have questions please post a comment.
Designing and uploading projects takes a lot of time please leave a tip if you can.
Thanks