Lithophane LED Stand Lamp

# English
---
+ The size of the side lithophanes should be ** 127mm x 170mm x 3mm **
+ The size of the top lithophane should be **170mm x 170mm x 3mm ** but I think the size 173x173 would work better.
+ It is recommended that the lithophane has a ** border of about 4-5mm **

it is important to consider the tolerance of the printer to ensure that the lithophanes fit correctly

I finally used a battery-powered light purchased at any electronics store, I guess a plug-in light will also work.

In the next version I will upload a model with a larger hole to be able to place a cable from inside of the Stand and be able to plug it in.


# Español
---
+ El tamaño de las litofanías laterales debe ser de ** 127mm x 170mm x 3mm **
+ El tamaño de la litofanía superior debe ser de **170mm x 170mm x 3mm ** pero posiblemente el tamaño de 173mm x 173mm funcionaria mejor
+ Es recomendable que la litofania tenga un borde de unos 4-5mm

Es importante considerar la tolerancia de la im