Lithophane Light Box

This is a Lithophane Light Box.
I used the online tool at https://itslitho.com/ to create the lithophanes. Basically you can upload any picture you want. Just keep in mind with this light box design, the image is going to be a square.

Box uses 4 photos: 1 Left, 1 Right, 1 Front, and 1 on Top.

These work for light sockets:
https://www.amazon.com/Pendant-Sockets-Sopoby-4-pack-Hanging/dp/B01M5F3DA2

I used a LED light (40w equivalent), since they put out less heat than other lights.

I have printed them in PLA and PETG, I think the PETG will probably hold up better for long term.

Settings for making lithophanes on website:

Dimensions 113mm x 113mm
Minimum thickness to 0.8
Maximum thickness to 3.2
Border 3mm

Print Settings:

Lithophanes using 100% infill and 0.1 layers,+ Brim single layer with 10 outlines

Box using 15% infill, 0.2mm layer height, 4 top/bottom layers, 3 outer layers

Top Corner pieces using 15%, 0.2 layer height,