Thingiverse
lithophane NightLight
by rhavin42
3
Downloads
2
Likes
0
Makes
I had a bunch of LED strips laying around, along with the barrel plug connectors that attach to them, so I designed a nightlight with changeable lithophanes.
The cutout for the dc-power port fits the handful of adapters that I have, but there might be different sized styles aside from the ones I have.
I used this site to create the lithophane https://3dp.rocks/lithophane/ I don't recall all the settings I used, aside from it was a solid cylinder 100mm in diameter. The ouput from that site was then printed in vase/spiralize mode.
The adhesive on the back of the LEDs were not strong enough to hold them to the post, so I superglued them with a rubberband around the LEDs until the glue dried.
Any old 12v adapter should work just fine.
Here is the tinkercad design I used for the base along with the feet which I glued on the bottom
The cutout for the dc-power port fits the handful of adapters that I have, but there might be different sized styles aside from the ones I have.
I used this site to create the lithophane https://3dp.rocks/lithophane/ I don't recall all the settings I used, aside from it was a solid cylinder 100mm in diameter. The ouput from that site was then printed in vase/spiralize mode.
The adhesive on the back of the LEDs were not strong enough to hold them to the post, so I superglued them with a rubberband around the LEDs until the glue dried.
Any old 12v adapter should work just fine.
Here is the tinkercad design I used for the base along with the feet which I glued on the bottom
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
