Thingiverse
Lithophane Picture Frame
by FLA_Labs
28
Downloads
17
Likes
0
Makes
Build Video: https://youtu.be/Qr3FI2pwmpw
This simple housing/frame is for a 150x100mm lithophane that is 7.5mm deep. I use https://lithophanemaker.com/Framed%20Lithophane.html to make my lithophanes.
Print all three pieces, install white LED strip inside the back piece, install your 150*100*7.5mm Lithophane and attach the frame with 4 screws. Its as simple as that!
UPDATE 12/1/2023
As requested, I have added two new versions of the back that have cut-outs for DC power jacks (7mm mounting hole) and rocker switches (10x15mm mounting hole). The switch is on the right and the DC power jack is on the bottom for each version.
These changes should accommodate the following parts:
DC Power Jack https://a.co/d/7VFT47M
Rocker Switch https://a.co/d/0lTK4zE
Special thanks to markjbell64 for the recommendation!
This simple housing/frame is for a 150x100mm lithophane that is 7.5mm deep. I use https://lithophanemaker.com/Framed%20Lithophane.html to make my lithophanes.
Print all three pieces, install white LED strip inside the back piece, install your 150*100*7.5mm Lithophane and attach the frame with 4 screws. Its as simple as that!
UPDATE 12/1/2023
As requested, I have added two new versions of the back that have cut-outs for DC power jacks (7mm mounting hole) and rocker switches (10x15mm mounting hole). The switch is on the right and the DC power jack is on the bottom for each version.
These changes should accommodate the following parts:
DC Power Jack https://a.co/d/7VFT47M
Rocker Switch https://a.co/d/0lTK4zE
Special thanks to markjbell64 for the recommendation!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!