Lithophane T Frame support

Lithophane T Frame stabilizer. I print lithophanes with a 4mm border for a custom box that I make. I make these up to 9" tall. For the best quality its important that the lithophane remain steady as the print gets taller. With my constraints of the frame the brim wasn't enough to eliminate wobble higher up in the print. After many attempts this was the solution. I have these in three heights and use 8x3 magnets to get them to hold down on the build plate. With two of clips on each tower they slide easily around the frame and can be set in place as you print. As the print gets taller you can slide the tower away and place the next higher one. You may want to pause the print the first few times but after a couple times I can now do it without pausing. Fusion file included if you want to change magnet sizes or make a taller tower. For custom tower sizes shorter than the max one on this plate just use the cut feature in bambu studio. I had posted this on a website as my solution an