Thingiverse
Litophane Box Frame
von yossi33
14
Downloads
9
Likes
0
Makes
This is a frame for a litophane box.
It enables you to install (and replace) four litophane pictures. It uses a standard 220V/110V bulb for lighting.
You need to print the frame and base and glue them together.
The side litophanes should be printed 14x14cm including a frame that is 0.5x0.5cm
The top litophane should be printed 15X15cm including a frame that is 0.5x0.5cm
On the back side there is a hole that fits a 4cm lamp socket
It enables you to install (and replace) four litophane pictures. It uses a standard 220V/110V bulb for lighting.
You need to print the frame and base and glue them together.
The side litophanes should be printed 14x14cm including a frame that is 0.5x0.5cm
The top litophane should be printed 15X15cm including a frame that is 0.5x0.5cm
On the back side there is a hole that fits a 4cm lamp socket
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
