Thingiverse
litter gripper
von shelxle
107
Downloads
88
Likes
0
Makes
Mirror the gripper to get the other one.
I had some leftover 14mm x 390mm pipes. The screws are just drilled directly in one of the gear teeth. I used just some wire as a bowden. A usual rubber band to keep the gripper open.
I had some leftover 14mm x 390mm pipes. The screws are just drilled directly in one of the gear teeth. I used just some wire as a bowden. A usual rubber band to keep the gripper open.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
