Little Bone Dragon

☠️✨ From the shadows of the crypt comes the Little Bone Dragon — tiny, bony, and hauntingly adorable! 🐉💀 #BabyBoneDragon #SpookyCute #3DPrintedDragon #BoneBuddy #RebelAlicorn #PrintInPlace #SkeletonStyle #HalloweenPrints I do not recommend making this little dragon smaller. The wings may be tight; hold the wings close to the ball on the wing, push in, and turn slightly. If you have a lot of trouble, sand or shrink the wings a percent smaller. Painted 3MF included. Please double-check that the settings work with your printer before starting. Always begin a new project and verify your flush settings to ensure the best results. Printing Recommendations: - Initial Layer and Initial Layer Infill - 25 mm/s- Layer Height: 0.20 mm - Initial Layer Line Width .35 - Walls: 3 Infill: 15% - Supports: None needed — this design prints in place! - Cooling: Let the plate cool completely before removing your print to avoid warping or damage. - Printer Acceleration: Slow down printer acceleration f