Little Nightmare

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 This print uses 6 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Blue Gray At layer #8 (0.72mm) swap to Gray At layer #11 (0.96mm) swap to Jade White At layer #15 (1.28mm) swap to Black At layer #17 (1.44mm) swap to Orange At layer #24 (2mm) swap to Yellow At layer #26 (2.16mm) swap to Jade White for the rest.