Thingiverse
LIXIL(Tostem)remote_control_key_case
von sebone777
0
Downloads
0
Likes
0
Makes
Probably only Japan is useful.
Uses TPU 95A.
No support is required, but since the overhang angle is 40 degrees, the nozzle size should be 0.4 mm or more, and the layer height should be 0.2 mm or more.
Uses TPU 95A.
No support is required, but since the overhang angle is 40 degrees, the nozzle size should be 0.4 mm or more, and the layer height should be 0.2 mm or more.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!