Thingiverse
LM2596 case for Ender 3
by dbunic
10
Downloads
8
Likes
0
Makes
This is case for two LM2596 (a commonly used popular step-down regulator) to mount inside Ender 3 - near main board. My idea was to use one regulator for motherboard fan and other for the hotend fan (it can be used for replacement fan that requires lower voltage instead of 24V).
Two main bolts are 4mm used with T-nut (for frame mount) and four small bolts are about 5mm in length (without head) and 2.5mm width.
Two main bolts are 4mm used with T-nut (for frame mount) and four small bolts are about 5mm in length (without head) and 2.5mm width.
dbunic also publishes on
14 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!