Thingiverse
LM393 light sensor case
by keithellis
7
Downloads
4
Likes
0
Makes
Case to hold an LM393 light sensor. I am using the LM393 to measure the pulse indicator on an electricity meter. The sensor is plugged into a microcontroller running mysensors.org sending the data into my Home-Assistant instance
To get the sensor to fit nicely on the meter I removed the light sensor and re-soldered it flush to the board. The sensor mount can then be stuck to the meter with self adhesive hook and loop tape.
Printing:
Printed at 0.15mm layer height in PLA. No support is required.
The top clips in snuggly when you are ready to seal up the box.
To get the sensor to fit nicely on the meter I removed the light sensor and re-soldered it flush to the board. The sensor mount can then be stuck to the meter with self adhesive hook and loop tape.
Printing:
Printed at 0.15mm layer height in PLA. No support is required.
The top clips in snuggly when you are ready to seal up the box.
keithellis also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!