Thingiverse
LM8UU Bearing
door cjinstalls7
7
Downloads
4
Likes
0
Makes
**UPDATE**
THE V2 HAS CHANGES TO THE INNER SPLINES. This could help with installation and printing closer to tolerance.
This is a printable version of The LM8UU glide bearing, I attempted to make this for My Anycubic Mega S. These bearings are bear to get printed up, but with lots of tuning and a smidge of luck they will work. Specs are 8mm I.D. 15mm O.D. and 45mm length. There are 3 Different I.D.'s 8.1, 8.15, and 8.18.
Pick a good filament that you trust, if you have elephants foot, fail- stringing, fail, room to hot or too cold fail- look at it sideways, fail. you get my drift. I will continue to work on this. I have delusions of printing this in delrin,,,,,HA HA HA Jokes on me. Anyway good luck
THE V2 HAS CHANGES TO THE INNER SPLINES. This could help with installation and printing closer to tolerance.
This is a printable version of The LM8UU glide bearing, I attempted to make this for My Anycubic Mega S. These bearings are bear to get printed up, but with lots of tuning and a smidge of luck they will work. Specs are 8mm I.D. 15mm O.D. and 45mm length. There are 3 Different I.D.'s 8.1, 8.15, and 8.18.
Pick a good filament that you trust, if you have elephants foot, fail- stringing, fail, room to hot or too cold fail- look at it sideways, fail. you get my drift. I will continue to work on this. I have delusions of printing this in delrin,,,,,HA HA HA Jokes on me. Anyway good luck
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
