Thingiverse
LMS8001 case
por roach118
6
Descargas
2
Likes
0
Makes
If you happen to own the LMS8001 companion board you'll know it was only supplied as a PCB.
This case allows you to safely mount the PCB, U.FL to SMA leads and even install a DC jack. This case should allow you to get a lot of utility out of your LMS8001.
The lid includes some handy information on which ports perform what actions. These instructions really slow the slicing down so if not required just remove from the SCAD and export.
The PCB mounts can be tapped with an M3 tap or a self tapping screw could be used.
Take care when removing supports from the front panel, the middle section is not very strong.
Add some little rubber feet so air can enter the lower vent
This print took 6 hours
This case allows you to safely mount the PCB, U.FL to SMA leads and even install a DC jack. This case should allow you to get a lot of utility out of your LMS8001.
The lid includes some handy information on which ports perform what actions. These instructions really slow the slicing down so if not required just remove from the SCAD and export.
The PCB mounts can be tapped with an M3 tap or a self tapping screw could be used.
Take care when removing supports from the front panel, the middle section is not very strong.
Add some little rubber feet so air can enter the lower vent
This print took 6 hours
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!