Thingiverse
Lock Assembly Altoids Case Insert
von Paintwarn
1
Downloads
1
Likes
0
Makes
For holding Pins springs and set screws for 6 pin locks inside an altoids case.
The radius is tight in order to prevent it from coming out, you need to align it correctly and give it a bit of a smack with your hand to install. No glue should be necessary.
The radius is tight in order to prevent it from coming out, you need to align it correctly and give it a bit of a smack with your hand to install. No glue should be necessary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
