Thingiverse
lock pinning shoe
44
Downloads
29
Likes
0
Makes
This is the body of my lock (re-)pinning shoe for Euro locks.
You just need to add the pinning needle. I make mine from hairclips (Mibella Basic), bent and cut to the right lenth (in an L shape - 20mm x 32mm).
At the back is a hole for a little setscrew, to hold the pinning needle in place. This way you can also adjust the hight and how tight it sits on the lock.
There are also two little side wings on the pinning shoe. You can use them to hold the shoe in place with a short rubber band, but that's usually not needed.
You just need to add the pinning needle. I make mine from hairclips (Mibella Basic), bent and cut to the right lenth (in an L shape - 20mm x 32mm).
At the back is a hole for a little setscrew, to hold the pinning needle in place. This way you can also adjust the hight and how tight it sits on the lock.
There are also two little side wings on the pinning shoe. You can use them to hold the shoe in place with a short rubber band, but that's usually not needed.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
