Thingiverse
Lock-Tab FlatRoll, Hexagonal Column
by syvwlch
28
Downloads
34
Likes
0
Makes
Another variant on the FlatRoll column idea... this time with locking tabs.
Can't be 100% certain until someone actually tries to print one, but I think this should print out just fine (if I didn't forget an overhang of greater than 45 degrees somewhere), and the locking tabs should lock nice and firm.
The thickness of the underside is easily adjusted in Sketchup, and the precise value to use depends on how thin a single layer in Skeinforge is... a number I currently do not know.
Can't be 100% certain until someone actually tries to print one, but I think this should print out just fine (if I didn't forget an overhang of greater than 45 degrees somewhere), and the locking tabs should lock nice and firm.
The thickness of the underside is easily adjusted in Sketchup, and the precise value to use depends on how thin a single layer in Skeinforge is... a number I currently do not know.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
