locker faceplate

This is a redesigned face plate for AMF bowling lockers. it is based on the original, but with changes to make it more durable than the original; even when 3d printed. In most cases they should install with no changes to the locker, but the bottom retention tab is different and hooks a tab on the door between the notches the old hooks used. Some times this is bent a bit in service and my need to be corrected with a pair of pliers before installing my replacement version. ( takes about 2500 milliseconds to do )

locker faceplate MB-s has built in support for the hook and locker face-plate MB does not.

locker faceplate WB is a backing plate for the number card. it just gets held in between the face-plate and the door. There is room for thick card stock and a protective transparency film or just cover the face of the card with a single strip of wide clear packing tape to keep it clean. pay careful attention to the slope on the window backing plate. it only should be installed in one