Thingiverse
Loft Bed Shelf
door PeterPrinciple
5
Downloads
2
Likes
0
Makes
My daughter got a loft bed and needed some kind of nightstand. Side slats were 20mm x 60mm with about 80mm between them. Designed this to slide onto the top slat to give her a small surface for easy access in bed.
shelfFitCheck is a small slice you can print to check fit and do minor scaling adjustments with a smaller filament and time commitment.
Small variants should fit in a 220x220x300mm print volume. Big variants increase height to 350mm for a little bigger surface.
Hole and non-hole varieties were my attempt to reduce filament.
shelfFitCheck is a small slice you can print to check fit and do minor scaling adjustments with a smaller filament and time commitment.
Small variants should fit in a 220x220x300mm print volume. Big variants increase height to 350mm for a little bigger surface.
Hole and non-hole varieties were my attempt to reduce filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!