Thingiverse
Logitech Brio Webcam Spacer
von SkyBeam
4
Downloads
6
Likes
0
Makes
Logitech Brio Ultra HD Webcam Spacer:
Do you also hate if your webcam is creating a "notch" on top of your fancy thin-frame screen?
This spacer will lift up your Brio by 5.5mm avoiding the front latch to sneak into your LCD/OLED panel and masking part of valuable screen space. Notches are accepted on phones but no need to accept them on desktop screens.
The spacer will clip in from bottom and securely snug to the front latch and clip in on the back of your OEM Brio mounting bracket. It should still leave enough room on the front to allow the OEM bracket rubberized inside to avoid the camera from sliding.
Do you also hate if your webcam is creating a "notch" on top of your fancy thin-frame screen?
This spacer will lift up your Brio by 5.5mm avoiding the front latch to sneak into your LCD/OLED panel and masking part of valuable screen space. Notches are accepted on phones but no need to accept them on desktop screens.
The spacer will clip in from bottom and securely snug to the front latch and clip in on the back of your OEM Brio mounting bracket. It should still leave enough room on the front to allow the OEM bracket rubberized inside to avoid the camera from sliding.
SkyBeam veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
