Thingiverse
Logitech C270 LED light ring
von Sp4wN
247
Downloads
176
Likes
0
Makes
Simple LED ring for Logitech C270
Use it with https://www.thingiverse.com/thing:1228521
The housing needs supports while printing.
There are 2 insert parts, these are neded to printed with white material, but you can also print the housing with white material and don't use the reflectors.
The screenshot from Octoprint is in total dark room, same goes for the timelapse video.
The Led stip should be 10mm you can get 60 LEDs per meter or 120 LEDs per meter Ledstrips, if the light is not enough don't put the diffuser on, but if it is to much put the diffuser on it. Every part fits tightly and don't need to be glued.
The video is for example, I just put the camera on the printer but C270 needs better mount on my printer: https://www.youtube.com/watch?v=ZHaCzJ1jKc4
Use it with https://www.thingiverse.com/thing:1228521
The housing needs supports while printing.
There are 2 insert parts, these are neded to printed with white material, but you can also print the housing with white material and don't use the reflectors.
The screenshot from Octoprint is in total dark room, same goes for the timelapse video.
The Led stip should be 10mm you can get 60 LEDs per meter or 120 LEDs per meter Ledstrips, if the light is not enough don't put the diffuser on, but if it is to much put the diffuser on it. Every part fits tightly and don't need to be glued.
The video is for example, I just put the camera on the printer but C270 needs better mount on my printer: https://www.youtube.com/watch?v=ZHaCzJ1jKc4
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
