Logitech G29 Switch Extension Remix

A remix of G29 Switch Extension.

I found the original not to work when tightened down. I think because it was tight, there wasn't enough flex at the pivot of the lever style switch.

I've essentially gone from 1 part to 3 parts to make some sort of hinge, that allows the plate to move more freely when fastened down.

Because the steering wheel is a little concave, after printing, I heated up the plate with a hairdryer and gave it a very slight bend.

The button actuation force is pretty low as it's on a lever, but I can't see a way around this without changing the switch.

In the future, it would be good to change this remix to something with an actual hinge, but I'm not experienced enough with modelling to figure that out.