Thingiverse
Logitech G29 Wheel Clamp Assembly
door Benjelum
13
Downloads
12
Likes
0
Makes
After my G29's clamp broke while tightening, I had trouble finding a replacement part, so I've gathered all pieces of a functional replacement assembly.
This clamp assembly was designed against a G29, but will be compatible with G27, G920, and probably any other logitech wheel where the clamp resembles this.
Assembly:
1) For a single clamp: print the Screw, Screw Grip, Screw Connector, and either the Clamp or the Extended Clamp
2) Disassemble wheel down to clamps, video guides are helpful
3) Press the Screw Connector into the Screw, dabs of super glue nice but optional
4) Press the Screw Grip onto the Connector dowel in the same way, the screw assembly is now complete
5) To assemble the clamp, remove it from the printer... yea
6) Thread the clamp up through the hole through the bottom where the original clamp passed
7) Spin down the Screw through the clamp onto it's footing inside the case
8) You're done! reassemble and enjoy.
This clamp assembly was designed against a G29, but will be compatible with G27, G920, and probably any other logitech wheel where the clamp resembles this.
Assembly:
1) For a single clamp: print the Screw, Screw Grip, Screw Connector, and either the Clamp or the Extended Clamp
2) Disassemble wheel down to clamps, video guides are helpful
3) Press the Screw Connector into the Screw, dabs of super glue nice but optional
4) Press the Screw Grip onto the Connector dowel in the same way, the screw assembly is now complete
5) To assemble the clamp, remove it from the printer... yea
6) Thread the clamp up through the hole through the bottom where the original clamp passed
7) Spin down the Screw through the clamp onto it's footing inside the case
8) You're done! reassemble and enjoy.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
